Who makes AR Blue Clean pressure washer?

Annovi Reverberi
AR Blue Clean is a consumer line of pressure washers from Annovi Reverberi (abbreviated AR) an Italian high pressure pump company with 58 years of pump building experience. All AR Blue Clean products sold in the United States are serviced by employees of AR North America located in Fridley, Minnesota.

What PSI is normally used to pressure clean?

However, according to Consumer Reports, water pressure is measured through PSI or pounds per square inch. The gas-powered pressure washers generally are between 2000 – 2800 PSI and electric-powered pressure washers are generally between 1300 – 1700 PSI.

How do I reset my pressure washer?

Each time the power cord is plugged in to an outlet, the Reset button on the GFCI module must be pressed down to connect to electricity. Check to see if the Reset button has been pressed. Next, confirm the small plastic window below the Reset button shows RED in the window.

Is AR Blue Clean a good brand?

The AR Blue Clean is a clear example of what you get when you buy a good, albeit average, pressure washer. While it does a fine job cleaning, it was more difficult to handle than half of the units we tested. It has good accessories, though its warranty is shorter than we’d like.

Where are AR Blue Clean pressure washers made?

Why The AR Blue Clean Brand? Quality Control A-Z – Annovi Reverberi manufacture their own pumps in a 157 employee manufacturing plant in Shanghai. They also make their own motors in Italy.

Is 1500 PSI good for a pressure washer?

A driveway should be pressure washed at a setting of 2300-3000 PSI. Be careful, especially when cleaning pathways as the mortar between the path stones can be damaged when pressure washing. A typical pressure of between 1500-2000 PSI should be used on pathways.

Is 1800 PSI good for a pressure washer?

The Greenworks 1800 PSI (GPW 1803) is a good entry-level electric pressure washer. With its included array of nozzles (below) it can do a wide range of cleaning tasks, from washing cars to stripping paint (at a slow rate).

Why does my electric pressure washer have no pressure?

Nozzles. A common cause for lost water pressure is when the nozzle at the end of the trigger-wand becomes worn or plugged. An uncommon spray pattern may be an indication that there is debris blocking the nozzle. Nozzles that are wearing will usually cause a gradual loss in pressure, as opposed to happening suddenly.

Is AR Blue a good pressure washer?

The AR Blue Clean AR383’s water pressure is good – at 1,900 PSI, it’s the second highest in our comparison. This meant it did well removing dirt and oil in our cleaning tests, though it didn’t match the two top-performing models we reviewed from RYOBI and Craftsman.