How do you make a Geeb without a socket?

1. Step 1 – Cut your smaller bottle. Cut the bottom section off your smaller bottle with your knife and discard it.
2. Step 2 – Make a hole in the bottle cap.
3. Step 3 – Shape your bowl.
4. Step 4 – Poke holes in foil.
5. Step 5 – Prepare your water.
6. Step 6 – Load your bowl.
7. Step 7 – Submerge your bottle in water.
8. Step 8 – Replace cap.

What piece do you need for a Geeb?

A gravity bong or a geeb is a method of consumption that requires two empty plastic bottles and uses air pressure and water to funnel smoke out of the device. This way, the smoke is pushed into the consumer’s lungs. This is a fairly easy method to consume cannabis in case you don’t have your smoking devices on you.

What do you smoke out of when you have nothing else?

If you have something to smoke, but nothing to smoke from, you can easily craft a smoking device out of household objects. They are easy to make, and can be fun to smoke out of. Fruit, pens, or water bottles can solve your smoking crisis.

How do you make a bong out of a water bottle and pen?

Step-by-step instructions to build a water bottle bong

1. Step 1: Prepare the plastic bottle. Find a plastic water bottle; the standard 17-ounce size works best.
2. Step 2: Prepare the downstem.
3. Step 3: Make a bowl.
4. Step 4: Insert the downstem.
5. Step 5: Make a carb hole.
6. Step 6: Add water.
7. Step 7: Pack the bowl.
8. Step 8: Spark up.

How do you use a JEEB?

Push down on the bottle slowly while inhaling. As you push the bottle down into the container, the smoke inside will be forced out and into your lungs. Don’t push down too quickly or you could take in too much smoke. Keep inhaling and pushing down until all the smoke is out of the bottle.

How do you make a coke can bong?

Steps

1. Get a pull-tab aluminum can.
2. Get a needle, pin or other sharp object.
3. Make an thumb-sized indention on side of the can.
4. Poke small holes.
5. Poke a large hole on the side.
6. Remove the tab off the can.
7. Condition the pipe by heating the smoking area and the adjacent area of the can.
8. Smoke.

Can you smoke out of a potato?

A potato is a great veggie to use for smoking because it’s easy to penetrate with a pen and requires no cutting or constructing. All you need to do is jab a pen through the top and through the side until the two tunnels connect. Scrape away access potato on the top, and there you have it: a potato pipe.

How do you make a Mason jar bong?

Fill the mason jar about 3/4 full of ice water, and screw on the lid. Load up your bowl with your finest herb, hold down the carb (if you have one), and light up while pulling through the mouthpiece. Release the carb or pull out the bowl/downstem assembly to release the smoke, and enjoy the ride!

How do you pull good jeebs?

Push down on the bottle slowly while inhaling. Don’t push down too quickly or you could take in too much smoke. Keep inhaling and pushing down until all the smoke is out of the bottle. If you feel like you can’t take in anymore smoke, take your mouth off the bottle.

How do you make a JEEB socket?

In case you were wondering, here is how to do it.

1. Pick a suitable socket.
2. Test the fit by placing the socket in the mouth of the bottle.
3. Wrap duct tape around the sides of the socket to create a tight seal.
4. Place fitted metal gauze into the socket to create a ‘bowl’ for your herb.
5. Cut a hole in the bottom of the bottle.

What is a potato bong?

noun. Scottish, Irish. A heap of potatoes, especially one covered with earth, straw, etc., for winter storage.