Which is the best brand of bearing Buddy?
Produced with the highest quality standards, to assure the durability that characterizes our product. With Genuine Bearing Buddy® your trailer, hubs and axles will always be protected. We continue selling millions of Genuine Bearing Buddy® around the world and guarantee you safe trips and protection for your investment.
How do you install a bearing Buddy protector?
Hit the back of the screwdriver with a hammer until it wedges between the bearing cap and the bearing. You don’t have to jack up the wheel or take the wheel off to install a Bearing Buddy protector because all you are doing is replacing the bearing dust cap, which can be removed with the wheel resting on the ground.
How to put bearing buddies on a wheel?
Hold a Bearing Buddy over a wheel’s bearing. Orient the Bearing Buddy protector so that the more hollow side faces the bearing and the side with the nozzle in the center faces outwards. Line the Bearing Buddy up with the wheel bearing and hold it in place against the bearing.
What to use to grease a bearing Buddy?
Fill the Bearing Buddy with bearing grease using a grease gun. Push the nozzle of the grease gun securely over the nozzle in the middle of the Bearing Buddy. Squeeze the grease gun’s handle to shoot grease into the bearing until you see the lubricant oozing out around the nozzle of the Bearing Buddy. [8]
When to install bearing Buddy caps on bearings?
Proceed to install your new Bearing Buddy caps if the bearings look like smooth, undamaged metal. Stop and replace the bearings before you go any further if you see any rust or corroded pits in the metal. Bearing Buddy protectors are designed to keep out moisture and dirt that can corrode and damage your bearings.
Why do you need bearing Buddy protectors for bearings?
Bearing Buddy protectors are designed to keep out moisture and dirt that can corrode and damage your bearings. If you do end up replacing your bearings before you install the new caps, the Bearing Buddy caps should prevent the need to do so any time again in the near future.
Do you need spindle seal on bearing Buddy?
With the Spindle Seal System, high-quality neoprene seals ride on a smooth stainless steel surface constantly greased by the action of Bearing Buddy®, which prolongs the life of the seals. If the axle spindles already have stainless steel seal surface rings permanently installed, you do not need Spindle Seal.
When is the best time to install bearing Buddies?
Note that you must repeat this process for each wheel that you want to install a Bearing Buddy on. Tip: If you’re regreasing your trailer wheel bearings, it could be a good time to install new Bearing Buddy protectors as well. Bearing Buddy caps will keep all the new grease clean and inside the bearings.
What do you need to know about bearing Buddy bra?
The Bearing Buddy® Bra is a vinyl cover that fits over the Bearing Buddy® to contain excess grease and keep it off tires and wheels. The Bearing Buddy® automatic pressure relief feature allows excess grease to escape if the hub is overfilled. Many users tend to overfill, and, during travel,…
How big is hub bore on bearing Buddy 1980?
The card can be used to select a Bearing Buddy® model based on the size of your dust cap. *The 1980 and 1980A both fit a hub bore of 1.980 inches, however the 1980A has a blue ring which acts as a visual lubricant level indicator inside the hub.
How to use a bearing Buddy on a boat?
Proper use of a bearing buddy is to pump grease in until the disk just begins to move outward. That will not pop the seal and will not force out any water. Properly used and provided you have a good seal water cannot get into the hub as there will be slight positive pressure on the hub.