How do you reset the brush bar on a Dyson DC24?

There are three buttons on the Dyson (DC24 was my model), two of which you use – ON/OFF switch and the BRUSH-BAR ON/OFF – but the third is hidden under the Brush-bar on/off switch. When you push the brush-bar button, it also activates the Reset Switch momentarily to get the motor going for the brush-bar.

How do you test a Dyson DC24 motor?

Hi its Darran at Dyson. Simply switch the machine off and stand it upright. Press the brush bar on/off switch once and then turn the machine back on. When you release the machine into the vacuuming position, the brush bar should start to turn again.

Why is my Dyson DC24 not picking up?

For cylinder Dyson vacuums troubleshooting suction problems is done by removing the hose at the main part of the machine and testing the suction, if it is poor clean or replace the filter, if it is good then the blockage is in the hose or handle. Disconnect the handles at each point to determine where the blockage is.

How do I fix the brush bar on my Dyson?

Most cases of a jammed or stuck brush bar are quick and easy to fix, simply pulling the debris gently from the brush bar. Alternatively, if you need to clear a problematic blockage, you can take the brush bar out of the housing easily, for quick maintenance.

Why does my Dyson brush Stopped Turning?

Most cases of a jammed or stuck brush bar are quick and easy to fix, simply pulling the debris gently from the brush bar. To get your vacuum cleaner brush bar spinning freely again, and to ensure your Dyson machine is working at maximum efficiency, select your machine below.

Why is the brush not spinning on my Dyson?

Can you turn off the beater bar on a Dyson?

Press the brush control button next to the On/Off switch to stop the brushes for use on delicate rugs, loop pile carpets and hard floors. Press the button again to restart the Brush bar for vacuuming carpets.

Why is my Dyson DC24 brush bar not working?

It will not spin when the machine is standing upright. The brush bar motors are prone to failure. This is a design fault in our opinion. There are two electrical components in the cleaner head that can go wrong. The brushbar motor and the printed circuit board (the PCB).

How do you replace the motor on a Dyson DC24?

Now you can unplug the motor from the circuit board. There is now one screw holding the motor in place. It is a T8 torx screw as indicated by the arrow in the picture below: Having undone that, the motor comes out. Replacing your motor is simply a reverse sequence of what you have just done.

Where is the reset button on a Dyson cleaner?

To recap, before we suspect the worst, look to the front of the machine on the cleaner brush head. On the left side is a small button. This is a “reset” button. Power the machine on and off whilst pressing it a few times. Do the same with the small brush switch next to the main power switch.

Can a brush bar motor go wrong on a cleaner head?

The brush bar motors are prone to failure. This is a design fault in our opinion. There are two electrical components in the cleaner head that can go wrong. The brushbar motor and the printed circuit board (the PCB).