What does E133 mean on my Baxi boiler?

E133. Indicates that the gas supply has been interrupted, ignition has failed or the flame has not been detected. Ensure that the gas supply has not been turned off, and turn the selector switch to the reset position and hold for at least 5 seconds. If the boiler does not relight, or the code is displayed .

How do you fix a flame failure on a Baxi boiler?

To reset the boiler, turn the selector switch to the R (Reset) position. Hold for at least 5 seconds and release. The fault code will be replaced with the boiler’s current temperature. At this point on a neon indicator boiler model, the flame failure light will stop flashing and will be replaced with the burner light.

Why is my Baxi boiler not firing up?

A common culprit for this fault on Baxi boilers is a lack of pressure. If your system is set lower than 1.5 bar then it won’t operate correctly. Now, the quick fix is to top up the pressure using the filling loop. Once you’ve topped up the pressure, you’ll need to reset the boiler.

Why does my Baxi boiler keep going off?

Common causes of a Baxi boiler locking out include overheating (110), fan fault (160), flue overheating (E131) and an issue with the printed circuit board (PCB) (E168).

Why does my boiler keep losing its flame?

Delayed ignition can be caused by a range of problems, including a restricted or weak pilot light. Also, low gas supply pressure can mean that there is too little gas at the burners, resulting in ignition problems. Another possible cause is too much primary air. This is air that’s mixed with gas before it’s ignited.

How do you fix flame failure?

Turn the Central Heating Temperature Control Knob clockwise to increase or anticlockwise to decrease the boiler flow temperature. If Flame Failure Light is ON press the Reset Button. If Flame Failure occurs frequently consult your Installer. This indicates that the Burner has fired up and is heating your system.

What does Error 1 mean on a boiler?

The Ideal boiler F1 error code is a common fault, displayed when the unit is low on water pressure. Luckily, this can be fairly simple to resolve yourself. It’s worth noting that the Ideal Logic range of boilers have a flashing F1 error code showing an ‘F’ followed by a ‘1’, this is the same error code.

Why would a boiler not ignite?

If the boiler is not igniting, there is a possibility the valve is blocked, seized or there is damage in the wired connections. No Pilot Light: When the boiler is not igniting and the pilot light has gone out, this usually means debris has blocked the jet.

What does E133 mean on a Baxi boiler?

E133 error code on a Baxi/ Potterton / Main boiler is an ignition lockout fault code. This error code that covers a wide range of possible faults connected to gas and igniton.

What does Baxi Duotec 28 he error code E133 mean?

Discussion in ‘ Plumbing and Central Heating ‘ started by leogem, 8 Jan 2010 . hi , i have a baxi duotec 28he boiler that when i try to relight reads e133 on the table of error codes, in the manual this means interuption of gas supply or flame failure. can anyone tell me what could be causing this

What is a temporary fault code on Baxi?

Temporary Fault – Maximum difference between the flow and return temperature exceeded. Non-existent or insufficient circulation. Sensor error. Log into baxiworks.co.uk for more information about this error code. Temporary Fault – Flow temperature increasing too fast in heating mode. Non-existent or insufficient circulation. Sensor error.

What to do if your boiler has an error code E133?

If your boiler has shut down and is showing error code E133 or E28, then your condensate pipe may be frozen. Please follow these steps to get your boiler up and running again: Switch your boiler off at the control panel, and turn off the electricity at the wall.