How do I identify a Chevy 5 speed transmission?

How do I identify a Chevy 5 speed transmission?

This 5-speed is based on the T4 Design. Aluminum case with top cover, internal single-rail shift with the shifter mounted on the extension housing. Casting numbers on the case, cover or extension housing are 13-51 or 13-52. 5th gear (overdrive) is located at the rear of the transmission in the extension housing.

Will a 4.3 motor bolt up to a 2.2 transmission?

Registered. Well they both are automatic trannys from 2.2l engines so it should work.

Which is better 5 or 6 speed transmission?

Efficiency. In recent 6-speeds, the extra speed from a 5-speed allows the engine to run at a lower RPM and save fuel, comparatively. This difference is most effective at highway driving speeds.

What manual transmission is in a 95 S10?

The Borg-Warner five-speed Tremec T5 five-speed manual served the S10 briefly in 1994 and 1995. It was a lightweight model with an aluminum case. It was popular for its high torque rating of up to 305 foot-pounds.

How do I know if I have a NV3500?

How to Identify a NV3500 Transmission

  1. Check the shift rail on the transmission. This particular transmission has a single shift rail, instead of a rail for each gear.
  2. Look at the body of the transmission. It has a front half and a back half.
  3. Locate the plugs.
  4. Look at the overall shape of the transmission.

What transmission does a 98 S10 have?

gm run the 4l60e trans in just about every rear wheel drive vehicle they make.

What’s a five speed automatic transmission?

A 5 speed shiftable automatic transmission provides the ease of use offered by an automatic transmission coupled with the sportiness and increased fuel economy offered by a manual transmission.

Did Muncie make a 5 speed?

Muncie also made 5 speed transaxles, but there was never a Muncie 5 speed in a Corvette.

What kind of transmission do I need for a Vortec motor?

Both the 4L60E and 4L80E transmission are reasonably priced in the aftermarket. With the right electronics, they are a bolt-on transmission solution for all Generation III Vortec or LS motors. However, although these transmissions have their benefits, the addition of electronics adds an extra step during a transmission swap.

Will a Vortec motor fit in a 350?

It will for sure bolt directly to the 350/305 engine, since in the 1/2ton variation they used the same tranny for those engines. As to the newer LS Series motor i believe the newer Vortec trannies are the same between the 4.3L and 4.8L however you will need the wiring for a manual tranny if you are swapping over from an auto to a manual.

What kind of transmission do I need for a GM V8?

Generally speaking, if you have a GM V8 motor manufactured between 1997-2007, direct swap solutions include the 4L60 and 4L80. And, the best manual option is the T56. If you have a GM motor produced after 2007, consider a 6L80 or 6L90 automatic transmission or the TR6060 manual transmission.

Can I swap a 4L60 motor for a Vortec motor?

Rest assured, there are harnesses and controllers on the market that will allow swapping the 4L60 or 4L80 into a generation four (2005 and newer) Vortec or LS motor. On the other hand, for some enthusiasts, automatic transmissions are a compromise not worth accepting.