How do you adjust the headlights on a 2001 Toyota Celica?

To raise the beam turn the top adjustment screw clockwise; counter clockwise to lower the beam. Turn the side adjustment screw clockwise to move the beam to the right and counterclockwise to move it to the left.

How do you adjust a Toyota Celica headlight?

Pop the hood and look directly behind the light. On the top center you will find a small screw that controls the vertical alignment. Along the side you will find the horizontal control screw. Use a screwdriver to tighten or loosen each screw until the light beam hits the center of the taped cross mark on the wall.

Where are the headlight adjustment screws?

Open the bonnet and look at the back of the headlight casing, on most models there will be two adjustment screws/bolts on the rear or top of each headlight-locate them and grab the right tool in order to turn them (check the owner’s manual to be sure they’re the right ones).

Which way do I turn my headlight adjuster?

Turn the screws clockwise to adjust the headlight inwards and counterclockwise to adjust them outwards. The headlight beam should fall just to the right of the center tapeline.

How do I adjust my horizontal headlights?

Adjust vertical aim. The horizontal line on the headlights should drop 1-2 inches down from the marked lines when parked 25ft back from the wall. Use the vertical adjustment screw to adjust the height of the headlights as necessary.

How do you adjust Toyota headlights?

1. Step 1 – Park your vehicle about 25 feet from a flat, vertical surface. It’s recommended that you use your garage door or a wall.
2. Step 2 – Pop the hood of your car.
3. Step 3 – Go clockwise or counterclockwise.
4. Step 4 – Adjust both headlights.
5. Step 5 – Check your work.

What is proper headlight adjustment?

The top of the low beam shining on the wall should be at or slightly below the height of the center of the headlight lens for most vehicles. You should expect the light pattern to be higher on the right side (passenger side) to illuminate road signs and lower on the driver’s side to prevent blinding other drivers.

How do I balance my headlights?

Clockwise turns should raise the lights, while counterclockwise turns should lower the lights. Turn the headlights on after adjusting and look at the light pattern on the wall. The top of the most intense part of the beam should be even with, or just below the center of the line of tape you made.

How high should headlights be at 25 feet?

Move the vehicle back 25 feet. With the aid of the tape line, the light beams should be roughly the same height vertically and horizontally. Vehicles have an adjustment screw or bolt on the headlight assembly for adjusting headlight height, and some also have a screw for horizontal aim.

How far should your headlights shine while on low beam?

about 160 feet
Q: How Far Should Your Headlights Shine While on Low Beam? A: According to the National Highway Traffic Safety Administration (NHTSA), the distance illuminated by low beam headlights is about 160 feet.

What is proper headlight height?