How do I know what amp to get for my car?

How do I know what amp to get for my car?

If you experience distortion at your desired volume level, you probably need an amplifier. To power a subwoofer: When you add a subwoofer to a car audio system, you almost always need to add an amplifier at the same time.

Why does my car stereo sound distorted?

You’re much more likely to hear distortion or cause damage if your amplifier is under powering the speakers. Higher volume means asking the amplifier for more power. If it is unable to provide enough, your speakers will distort. If the speaker components are poor quality, then heat damage may occur.

Does my car have a factory amplifier?

There are a few ways to find out if your factory system has an amplifier system. One way is to verify if your system has more than four speakers. If it does it probably has an amplifier. You may also want to check with your factories owner’s manual to see what type of system that you have.

Why are my speakers popping in my car?

A break in this circuit or a loose connection will cause the system to pop or make popping noises that can be annoying and dangerous to the health of your speakers. This popping is a surge of electrical current jumping over a broken or bad wire connection, or a surge in your output settings from the amplifier.

How do you stop distortion?

You can prevent speaker distortion by watching a sound meter readings when you get to the loudest part of the event and then reducing the board volume to keep it under the limit.

Does a 2010 Chevy Malibu have a factory amp?

The 2010 Chevy Malibu factory amp location is under the rear seat on the passenger side. You will come into problems with the sound. The amp on the 2010 Chevy malibu is located under the rear seat on the passenger side. …

How do I get rid of the engine noise in my car stereo?

How to Eliminate Engine Noise

  1. 1) On the head unit, turn the volume down to zero.
  2. 2) Turn the gain up on the amplifier until you can hear the engine/alternator noise.
  3. 3) Unplug all of the RCA cables at the amplifier.
  4. 4) Plug the RCA cables back into the amplifier.
  5. 5) Unplug the RCA cables from the head unit.